Fuel Gauge Stabilizer – All 356s 50-65

Fuel Gauge Stabilizer for all 356 (1950-1965) models. Eliminates wild swings in fuel gauge readings. Installs in minutes – instructions below. This can be used with 6 and 12 volt with conversion kits and will eliminate “jumping” or back and forth motion of the fuel gauge needle.

Instuctions:
– Make sure ignition is turned off. Remove ignition key
– Remove thumb screw from fuel gauge mounting bracket
– Install brown wire w/ring terminal from dampener unit to gauge mounting stud and replace thumbscrew
– Remove wire from back of fuel gauge terminal marked (G)* Pull this wire gently off with needle nose pliers
– Install above wire you removed from the (G)* terminal into female terminal of gauge dampener unit
– Install male terminal from gauge dampener back into fuel gauge terminal (G)*
– Installation is done

FYI: It is not uncommon for the gauge to register full (F) rather than empty (E) for a few seconds after the key is turned off. It may take 5-60 seconds for the current to drain from the capacitor. This harms nothing & draws no current. It is a normal function of the unit. If the gauge needle stays in the F position all of the time the needle may be sticking.
**(G) means gauge.